PCB Annular ringsTuesday,Oct 11,2016
A copper ring attached to the surface of a pad around a connecting hole wall. Drill size (Aperture) is the the size of the hole diameter.
 An Annular Ring Width = (diameter of the pad - diameter of the hole) / 2 Normally Min width for Annular Ring is 0.15mm(6mil). Drill Sizes (CNC): 0.2-6.3mm.(Min drill size is 0.2mm, max drill is 6.3mm. Any holes greater than 6.3mm or smaller than 0.3mm will be subject to extra charges)  Eg: 1. R=0.12mm H=0.2MM D=0.44MM The Annular Ring Width=(0.44-0.2)/2=0.12mm 2. R=0.15mm H=0.3MM D=0.6MM The Annular Ring Width=(0.6-0.3)/2=0.15mm |
